Most parapet leaks enter through open coping joints on top of the wall, through base flashing that has split or pulled loose, or through brick and mortar that soak up water. A clogged drain or scupper holding water against the wall makes all three worse.
Get My Free Estimate →- Where parapet walls leak
- Coping caps on top of the wall
- Base flashing where the roof meets the wall
- When the wall itself lets water in
- Scuppers and drains along the parapet
- Parapet leak or roof leak?
- What to do when a parapet wall leaks
- How a parapet leak is repaired
- Repair now or plan a recover?
- Get your parapet walls checked
- FAQs
Most parapet wall leaks enter in one of three places. Water gets in through the coping on top of the wall, through the base flashing where the roof membrane turns up the wall, or through the brick and mortar of the wall itself.
Inside, a parapet leak usually shows on an exterior wall just below the roof as a stain, blistering paint or bowed drywall. Buckshot repairs commercial flat roofs across Dane County from our Madison headquarters, and this guide shows how the entry point is found.
Where parapet walls leak
Where the water appears, and when, points to where it gets in.
| What you see | Likely entry point | What it takes |
|---|---|---|
| Stain high on an exterior wall after wind-driven rain | Open joints or failed sealant in the coping | New joint covers or new coping, with membrane under it |
| Water at the base of the wall after any rain | Base flashing split at a corner or pulled loose | New membrane flashing up the wall |
| Membrane pulled tight across the angle where roof meets wall | An aging membrane shrinking | New base flashing, or a recover if the whole roof is worn |
| Damp or crumbling brick on the roof side of the wall | Water soaking into the masonry | Membrane over the top of the wall, with masonry repair coordinated |
| Leak near an opening through the wall | A failed scupper or collector box seal | A re-flashed scupper |
| Leak only after water stands against the wall | A clogged drain or a low spot at the wall | Drainage work and new flashing |
Coping caps on top of the wall
Coping is the cap that covers the top of a parapet wall, usually formed metal on newer buildings and stone or precast concrete on older ones. It sheds water off the top of the wall, and its joints are where it fails first.
Metal coping comes in sections joined by cover plates and sealant. Fasteners work loose as the metal expands and contracts, and sealant hardens and cracks after a few Wisconsin winters, so water runs through the joints into the wall.
Stone and precast coping fail at the mortar joints between the pieces. Our commercial winter checklist lists the coping problems to look for before the freeze, from missing fasteners to cracked sealant.
The perimeter is also where wind attacks a flat roof. Loose coping or edge metal lets wind get under the membrane, and a lifted edge is how a storm starts peeling a roof back.
Base flashing where the roof meets the wall
At the base of the parapet, the roof membrane turns up the wall as base flashing. It should rise at least 8 inches above the roof surface, held at the top by a termination bar and covered by counterflashing or the coping.
Base flashing fails at the inside and outside corners first, where the membrane is cut and folded. Adhesive lets go with age, the termination bar loosens, and the sealant along its top edge dries out.
An aging membrane also shrinks. It pulls tight across the angle where the roof meets the wall until it bridges the gap and tears, a late-life sign our guide to commercial roof warning signs describes.
Each membrane is repaired its own way. TPO and PVC take heat-welded patches, EPDM takes primed seam tape and cover patches, and modified bitumen takes a new cap sheet matched to the existing roof.
When the wall itself lets water in
Brick, block and stone absorb water. A parapet is exposed on both faces and the top, so it soaks up rain and melting snow from every side, and freeze-thaw cycles crack the mortar joints.
Water that enters the wall at the top can travel down inside it and appear well below the roof. That is why sealing the roof alone often fails to stop a parapet leak.
The lasting fix is to carry the membrane up the inside face of the parapet and over the top, then set new coping over it. Where the brickwork itself needs rebuilding, we flag it and coordinate that work so the roof repair holds.
Scuppers and drains along the parapet
A scupper is an opening through the parapet at roof level that drains water into a collector box and downspout. Scuppers are common on older brick buildings in downtown Madison and Stoughton, and the flashing around the opening is a frequent leak point.
When a drain or scupper clogs, water stands against the base of the wall and finds every weak spot in the flashing. Our guide to commercial roof drainage explains scuppers, overflow scuppers and the 48-hour ponding rule.
Parapet leak or roof leak?
The timing of the leak narrows it down. A leak that follows wind-driven rain from one direction points to the coping or the wall face, while a leak during any rain points to the base flashing or the roof itself.
A stain that starts where the wall meets the ceiling points to the parapet. A stain in the middle of the ceiling usually comes from the open roof, a seam or a penetration.
A water test confirms the entry point by wetting one section at a time, starting low and working up the wall. An infrared survey or a core cut shows whether the insulation under the membrane is wet, which decides between a repair and a recover.
Want a straight answer on your roof?
We'll inspect it, document everything, and tell you honestly what you're looking at, even if the answer is patch it for now. No pressure.
What to do when a parapet wall leaks
- Protect what is below. Move inventory and equipment away from the wall and put down containers or tarps.
- Note when it leaks. Record the date, the weather and the wind direction each time water appears.
- Photograph the damage. Date-stamped photos of the interior wall and ceiling help with the repair scope and any insurance claim.
- Keep drains clear. If someone trained for roof access can reach them safely, clear leaves and debris from drains and scuppers near the leak.
- Skip the caulk. Sealant smeared over coping joints or flashing traps water in the wall and makes the real repair harder.
Water coming in at a parapet now? Our 24/7 line at (608) 909-9109 covers active leaks on any membrane. For a slower leak, schedule a free commercial roof assessment with a written photo report.
Free on-site inspection · Family-owned since 1979How a parapet leak is repaired
- Trace the entry point. The coping, base flashing, wall faces, scuppers and drains are checked together, with a water test where the source is not obvious.
- Re-flash the base. New membrane flashing goes up the wall at least 8 inches, sealed at every corner and held by a termination bar.
- Wrap the top of the wall. The membrane continues up the inside face and over the top, so the wall stays dry even if a coping joint opens later.
- Set new coping. New metal coping goes on over cleats, with sealed joint covers and a drip edge on both faces.
- Coordinate the masonry. Where mortar or brick has failed, that work is scheduled with the roof repair so the wall dries out and stays dry.
- Document the work. You receive photos and a written scope for your records, budget and any insurance claim.
Our commercial roof repair crews work on TPO, EPDM, modified bitumen and built-up roofs, and schedule around your operating hours.
Repair now or plan a recover?
A parapet leak on a sound roof is a repair. If the membrane is cracking, shrinking or holding wet insulation across the roof, the flashing work is often done as part of a recover or replacement instead.
Our guide to roof coating or replacement explains how that choice is made. A maintenance program catches open coping joints and loose flashing before they leak.
Get your parapet walls checked
Buckshot is family-owned, has served building owners since 1979, and serves Madison and Dane County commercial properties from 621 N Sherman Ave in Madison. We respond to commercial roof inquiries within 2 hours, and our Madison commercial roofing page covers our full flat roof work.
Call (608) 909-9109 to schedule a free commercial roof assessment, or send us a message. Property managers in Middleton, Fitchburg, Sun Prairie and across the county can also start from our commercial roofing in Madison page.
Get a straight answer on your Madison roof
Wisconsin storm season and insurance non-renewal letters do not wait. Get a free, no-obligation inspection and an honest assessment of exactly what your roof needs, even if the answer is to wait.
Frequently Asked Questions
Why is my parapet wall leaking?
How do you fix a leaking parapet wall?
What is parapet coping?
Should the roof membrane go over the top of a parapet wall?
How can I tell a parapet leak from a roof leak?
Written by Chad Yates, Owner, Buckshot General Contracting. Chad grew up in Orfordville, Wisconsin and learned the roofing trade from the ground up, working as a laborer alongside his brothers before founding Buckshot. He and his crew replace and restore roofs across Madison and south-central Wisconsin. Every guide is reviewed for accuracy by our local project crew before it goes live.
Buckshot General Contracting · GAF Master Elite · FORTIFIED Provider · Licensed & insured · 24/7 storm line (608) 909-9109