Roofing GuideBy Chad Yates, Owner·Updated November 2026·7 min read
Downspout Leaking? Joints, Elbows and Fixes on Green County Homes
Quick answer

Most often the sections are fitted the wrong way, so water runs out of the joint instead of into the piece below. A clog lower in the downspout, a split seam or loose straps that let the joints open are the other usual causes.

Get My Free Estimate →
Since 1979
Family-owned · 47+ yrs
GAF Master Elite
Top-tier certified
Roof provider
★★★★★
24/7 storm line

A downspout that leaks at the joints usually has one of four problems. The sections are fitted the wrong way round, something is clogging the pipe below the leak, a seam or elbow has split, or loose straps have let the joints pull apart.

Each of those puts water against your siding and foundation. Buckshot repairs gutters and downspouts across Green County from our office on W Hafeman Rd in Brodhead, and this guide shows how to tell which problem you have.

Where downspouts leak

Where the water comes out points to the cause.

Where it leaksLikely causeWhat it takes
Where the downspout meets the gutterA failed seal around the gutter outletA resealed or replaced outlet
At a joint between straight sectionsSections fitted the wrong way, or a clog belowRefitting and fastening the joint, or clearing the clog
At an elbowA split elbow, or an elbow fitted the wrong wayA new elbow
Along a straight sectionA seam split by iceA new section
Down the wall behind the downspoutLoose straps letting the run lean and the joints openNew straps into solid wall
At the bottomA crushed end or a clogged extensionA new bottom elbow and extension

Joints fitted the wrong way

Each downspout section has one narrower, crimped end. That end slides down inside the section below, so water inside the pipe always runs past the joint rather than out of it.

When a piece goes in upside down, the joint faces the wrong way and water pours out every time it rains. Sealant over a backwards joint only lasts until it peels, so the fix is to refit the pieces and fasten each joint with short screws or rivets.

A clog below the leak

A joint that only leaks in heavy rain often has a clog below it. Leaves, shingle granules, seed pods or a nest block an elbow, water backs up the pipe, and it escapes at the first joint above the blockage.

Clear the downspout from the bottom elbow up and flush it with a garden hose. If it fills again quickly, the gutter above needs cleaning or guards, and our guide to gutter drainage covers the other reasons water backs up.

A downspout tied into a buried pipe can also back up from below. Our guide to underground downspout drains explains how those lines clog and how they are cleared.

Split seams and cracked elbows

Water that freezes inside a downspout expands and splits the seams, and elbows crack first because water collects in the bend. Hitting a frozen downspout to break the ice splits it too, as our guide to a frozen downspout explains.

A split elbow or section should be replaced rather than caulked. Sealant cannot hold against water running under pressure inside the pipe, and a new piece costs little next to the water damage a split causes.

Downspout elbow turning onto a splash block beside a vinyl-sided wall

Loose straps and leaning runs

Straps hold the downspout tight to the wall. When their fasteners pull out of the siding or trim, the run leans away from the wall and the joints open as it moves in the wind.

Water then runs down the outside of the pipe and the wall behind it, soaking the siding and the sill. New straps fastened into solid wall at the top, the bottom and along the run hold it straight again.

Downspouts running from the gutters down a lap siding wall

Is the downspout too small?

A downspout that overflows at the top or leaks at every joint in a downpour may be too small for the roof above it. One standard 2x3 downspout handles about 600 square feet of roof, and a larger 3x4 handles about 1,200.

Our guide to how many downspouts you need explains how to count them. The fix is a larger downspout or a second one on that run.

Want a straight answer on your roof?

We'll inspect it, document everything, and tell you honestly what you're looking at, even if the answer is patch it for now. No pressure.

Why a leaking downspout matters

Water leaking from a joint lands against the siding and the foundation instead of being carried away. Our downspouts page explains why discharge should land at least 6 feet from the wall, and a leak halfway down defeats that.

In winter, water leaking from a joint freezes on steps, walks and driveways. Our guides to downspout drainage and gutters damaging the foundation cover where the water goes next.

What you can check from the ground

  1. Watch it in the rain. Note whether water comes out of one joint, every joint or only the top.
  2. Look at the joints. Each upper piece should sit inside the one below it.
  3. Look at the elbows. Check the bends for splits and the bottom elbow for crushing.
  4. Push on the run. A downspout that moves or leans away from the wall has loose straps.
  5. Check the bottom. Clear the opening and make sure the extension carries water well clear of the house.

Downspout leaking on your house? Our gutter and downspout inspection is free, and we reply within 2 hours. Call (608) 909-9109 to schedule it.

Free on-site inspection · Family-owned since 1979

How we fix a leaking downspout

  1. Clear the run. The downspout and its elbows are cleared from the bottom up, and the gutter outlet is checked.
  2. Refit the joints. Pieces fitted the wrong way are turned around, and each joint is fastened.
  3. Replace split pieces. Split sections and cracked elbows are replaced with color-matched aluminum.
  4. Re-strap the run. New straps go into solid wall so the downspout stays tight to the house.
  5. Size it right. Where one downspout cannot keep up, it is upsized or a second one is added.
  6. Carry the water away. An extension or underground drain takes the water at least 6 feet from the foundation.

Our gutter repair crews handle the gutters at the same visit, resealing leaking seams and outlets as our guide to gutters leaking at the seams describes.

Get your downspouts fixed in Green County

Buckshot is family-owned and has served southern Wisconsin since 1979. Our own crews handle roofs, siding and gutters across Green and Rock counties from our office in Brodhead, including Monroe, Albany, Monticello and New Glarus.

Call (608) 909-9109 to schedule a free gutter and downspout inspection, or send us a message and we will set a time.

Get a straight answer on your Madison roof

Wisconsin storm season and insurance non-renewal letters do not wait. Get a free, no-obligation inspection and an honest assessment of exactly what your roof needs, even if the answer is to wait.

Frequently Asked Questions

Why is my downspout leaking at the joints?
Most often the sections are fitted the wrong way, so water runs out of the joint instead of into the piece below. A clog lower in the downspout, a split seam or loose straps that let the joints open are the other usual causes.
Which way do downspout sections go together?
The narrower, crimped end of each upper section goes down inside the section below it. Water then always flows into the next piece instead of out through the joint.
Can you caulk a leaking downspout joint?
Sealant can slow a small leak on a joint that is fitted correctly, but it fails on a backwards joint or a split. The lasting fix is to refit or replace the piece and fasten the joint.
Why does my downspout leak at the elbow?
Elbows collect water and debris in the bend, so they clog first and split first when water freezes. A clogged elbow backs water up and out of the joint above it, and a split elbow needs replacing.
Why is water running down the wall behind my downspout?
Usually the straps have pulled loose, so the run leans away from the wall and the joints open. A leaking gutter outlet at the top can also send water down the back of the pipe.

Get a real number for your project

Cost ranges only get you so far. Tell us your address, what's going on, and the scope you're considering, and we'll get you a clear, honest estimate with no obligation.

Free, no-pressure estimates. We'll walk the project with you and explain every line of the quote before you decide anything.

Family-Owned · Since 1979GAF Master EliteFORTIFIED Provider

Wisconsin Dwelling Contractor · Lic. #DC-080900045

Explore our services
Keep reading
About the author

Written by Chad Yates, Owner, Buckshot General Contracting. Chad grew up in Orfordville, Wisconsin and learned the roofing trade from the ground up, working as a laborer alongside his brothers before founding Buckshot. He and his crew replace and restore roofs across Madison and south-central Wisconsin. Every guide is reviewed for accuracy by our local project crew before it goes live.

Buckshot General Contracting · GAF Master Elite · FORTIFIED Provider · Licensed & insured · 24/7 storm line (608) 909-9109